openwrt/target/linux/lantiq/dts/ARV752DPW.dts
blogic b7fc892eb5 lantiq: move partitions into partion table node
Starting with kernel 4.4, the use of partitions as direct subnodes of the
mtd device is discouraged and only supported for backward compatiblity
reasons.

Signed-off-by: Mathias Kresin <openwrt@kresin.me>

SVN-Revision: 49280
2016-05-10 10:43:12 +02:00

239 lines
4.2 KiB
Plaintext

/dts-v1/;
/include/ "danube.dtsi"
/ {
model = "ARV752DPW - Arcor 802";
chosen {
bootargs = "console=ttyLTQ0,115200 init=/etc/preinit";
leds {
boot = &power_red;
failsafe = &power_blue;
running = &power_red;
internet = &internet_red;
wifi = &wifi;
};
};
memory@0 {
reg = <0x0 0x4000000>;
};
sram@1F000000 {
vmmc@107000 {
status = "okay";
gpios = <&gpiomm 1 0>;
};
};
fpi@10000000 {
localbus@0 {
nor-boot@0 {
compatible = "lantiq,nor";
bank-width = <2>;
reg = <0 0x0 0x800000>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "uboot";
reg = <0x00000 0x10000>;
read-only;
};
partition@10000 {
label = "uboot_env";
reg = <0x10000 0x10000>;
read-only;
};
partition@20000 {
label = "firmware";
reg = <0x20000 0x7d0000>;
};
partition@7f0000 {
label = "board_config";
reg = <0x7f0000 0x10000>;
read-only;
};
};
};
mac_addr {
compatible = "lantiq,eth-mac";
reg = <0 0x7f0016 0x6>;
mac-increment = <2>;
};
gpiomm: gpiomm@4000000 {
compatible = "lantiq,gpio-mm";
reg = <1 0x0 0x10 >;
#address-cells = <1>;
#size-cells = <1>;
#gpio-cells = <2>;
gpio-controller;
lantiq,shadow = <0x3>;
};
};
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
ebu {
lantiq,groups = "ebu cs1";
lantiq,function = "ebu";
};
exin {
lantiq,groups = "exin1";
lantiq,function = "exin";
lantiq,pull = <2>;
lantiq,output = <0>;
};
pci_in {
lantiq,groups = "req2", "req1";
lantiq,function = "pci";
lantiq,open-drain = <1>;
lantiq,pull = <2>;
lantiq,output = <0>;
};
pci_out {
lantiq,groups = "gnt1";
lantiq,function = "pci";
lantiq,output = <1>;
};
pci_rst {
lantiq,pins = "io21";
lantiq,pull = <2>;
lantiq,output = <1>;
};
leds {
lantiq,pins = "io3", "io5", "io6", "io8";
lantiq,output = <1>;
lantiq,pull = <0>;
};
keys {
lantiq,pins = "io11", "io12", "io13", "io28";
lantiq,output = <0>;
lantiq,pull = <2>;
lantiq,open-drain = <1>;
};
};
};
ifxhcd@E101000 {
status = "okay";
gpios = <&gpiomm 0 0>;
};
etop@E180000 {
phy-mode = "rmii";
};
pci@E105400 {
status = "okay";
lantiq,external-clock;
gpio-reset = <&gpio 21 0>;
interrupt-map = <0x7000 0 0 1 &icu0 135>;
req-mask = <0x3>;
};
};
ralink_eep {
compatible = "ralink,eeprom";
ralink,eeprom = "RT2860.eeprom";
};
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <100>;
/* wps {
label = "wps";
gpios = <&gpio 11 1>;
linux,code = <0x211>;
}; */
restart {
label = "restart";
gpios = <&gpio 12 1>;
linux,code = <0x110>;
};
dsl {
label = "dsl";
gpios = <&gpio 13 1>;
linux,code = <0x111>;
};
reset {
label = "reset";
gpios = <&gpio 28 1>;
linux,code = <0x198>;
};
};
gpio-leds {
compatible = "gpio-leds";
power_blue: power1 {
label = "arv752dpw:blue:power";
gpios = <&gpio 3 1>;
};
internet_red: internet {
label = "arv752dpw:red:internet";
gpios = <&gpio 4 1>;
};
message {
label = "arv752dpw:red:message";
gpios = <&gpio 5 1>;
};
power_red: power {
label = "arv752dpw:red:power";
gpios = <&gpio 6 1>;
default-state = "keep";
};
voice1 {
label = "arv752dpw:red:voice";
gpios = <&gpio 8 1>;
};
microphone {
label = "arv752dpw:red:umts";
gpios = <&gpiomm 3 1>;
};
wifi: wifi {
label = "arv752dpw:red:wifi";
gpios = <&gpiomm 4 1>;
};
fxs1 {
label = "arv752dpw:green:tae-n";
gpios = <&gpiomm 5 1>;
};
fxs2 {
label = "arv752dpw:green:tae-u";
gpios = <&gpiomm 6 1>;
};
fxo {
label = "arv752dpw:green:isdn";
gpios = <&gpiomm 7 1>;
};
internet2 {
label = "arv752dpw:blue:internet";
gpios = <&gpiomm 8 1>;
};
voice2 {
label = "arv752dpw:blue:voice";
gpios = <&gpiomm 9 1>;
};
};
};